Q1Driving doubles & triples
Compared with other commercial vehicles, how stable are doubles and triples?
- AMore stable, because the weight is spread over more axles
- BAbout as stable, as long as the load is balanced
- CMore stable on the highway but less stable in town
- DLess stable, with more that can go wrong
Show answerHide answer
Answer D Less stable, with more that can go wrong
Rigs with two or three trailers handle less steadily than other big rigs and have more points of possible failure, so the handbook calls for extra care when pulling them.
Texas CDL Handbook §7.1
Q2Driving doubles & triples
A certain speed is safe on a curve when you pull a single trailer. What about the same curve with doubles or triples?
- AThat speed may be too fast; slow down and steer gently
- BThe same speed is safe, since the tractor is the same
- CYou can go a bit faster, because the extra trailer helps hold the road
- DSpeed matters only on ramps, not on ordinary curves
Show answerHide answer
Answer A That speed may be too fast; slow down and steer gently
Rigs with two or three trailers can roll over at a curve speed that is fine for a straight truck or a one-trailer rig. Slow down and steer gently on curves and on- and off-ramps.
Texas CDL Handbook §7.1.1
Q3Driving doubles & triples
Why should you look far down the road when pulling doubles or triples?
- ASo you can wait and brake hard at the last moment
- BSo you can stay in the left lane longer
- CSo you have time to slow down or change lanes gradually
- DSo you can time your gear changes to save fuel
Show answerHide answer
Answer C So you have time to slow down or change lanes gradually
Doubles and triples have to be driven very smoothly, or they can roll over or jackknife. Spotting trouble early lets you make slow, gradual changes instead of sudden ones.
Texas CDL Handbook §7.1.4
Q4Driving doubles & triples
On slippery roads or in the mountains, why is there a greater chance of skids and lost traction with doubles and triples?
- AThe rig is longer and the drive axles must pull more dead axles
- BThe converter dolly steers the rear trailer
- CTheir trailers have no brakes of their own
- DThey have fewer tires touching the road
Show answerHide answer
Answer A The rig is longer and the drive axles must pull more dead axles
A double or triple is longer and has more non-driven axles for the drive axles to pull than other rigs. In bad weather that makes skids and loss of traction more likely, so take extra care.
Texas CDL Handbook §7.1.6
Q5Converter dollies
What is a converter dolly (converter gear)?
- AA small hand truck for moving freight inside a trailer
- BA one- or two-axle unit with a fifth wheel used to hook a semitrailer behind a tractor-trailer
- CA device that turns air pressure into electric power for the trailer lights
- DAn extra axle added under the tractor to carry more weight
Show answerHide answer
Answer B A one- or two-axle unit with a fifth wheel used to hook a semitrailer behind a tractor-trailer
A converter dolly carries a fifth wheel on one or two axles, so a semitrailer can be hitched behind a tractor-trailer to form a double.
Texas CDL Handbook §7.2.1
Q6Converter dollies
How can you tell that a converter dolly has antilock brakes (ABS)?
- AIt has a red lamp on the right side
- BIt has a blue sticker on the tow bar
- CIt has a yellow lamp on the left side
- DIt has a green lamp on the rear
Show answerHide answer
Answer C It has a yellow lamp on the left side
Dollies built on or after March 1, 1998 must have ABS, and these dollies have a yellow lamp on the left side.
Texas CDL Handbook §7.1.8
Q7Converter dollies
A converter dolly without spring brakes is parked with its brakes set. How do you release its brakes before moving it?
- ARaise the dolly support
- BPull the pintle hook release
- COpen the dolly's air tank petcock
- DConnect only the service line to the dolly
Show answerHide answer
Answer C Open the dolly's air tank petcock
Opening the petcock on the dolly's air tank lets the dolly brakes release. A dolly with spring brakes is released with its parking brake control instead.
Texas CDL Handbook §7.2.1
Q8Coupling
Your two trailers carry different loads. How should you arrange them for the safest handling?
- ALighter trailer right behind the tractor, heavier trailer in the rear
- BIt does not matter as long as both are under the weight limit
- CPut the trailer with the newest brakes in the rear
- DHeavier trailer right behind the tractor, lighter trailer in the rear
Show answerHide answer
Answer D Heavier trailer right behind the tractor, lighter trailer in the rear
Put the heavier trailer up front, coupled directly to the tractor, and the lighter one at the back.
Texas CDL Handbook §7.2.1
Q9Coupling
Before backing the converter dolly under the rear trailer, how high should the trailer be?
- AExactly level with the top of the dolly's fifth wheel
- BSlightly lower than the center of the dolly's fifth wheel
- CWell above the dolly's fifth wheel so they do not touch
- DAs low as the landing gear will go
Show answerHide answer
Answer B Slightly lower than the center of the dolly's fifth wheel
With the trailer set just below the center of the fifth wheel, the dolly lifts the trailer a little as it slides under.
Texas CDL Handbook §7.2.1
Q10Coupling
When coupling twin trailers, what is the final step after you raise the second trailer's landing gear completely?
- AOpen the dolly's air tank petcock and listen for air
- BLower the landing gear of the second trailer
- CUnlock the pintle hook and pull forward gently
- DCharge the trailer brakes and open the emergency line shut-off at the rear of the second trailer to check for air
Show answerHide answer
Answer D Charge the trailer brakes and open the emergency line shut-off at the rear of the second trailer to check for air
Push the air supply knob in to charge the brakes, then open the emergency line shut-off at the back of the second trailer. If air pressure does not reach it, something is wrong and the brakes will not work.
Texas CDL Handbook §7.2.1
Q11Uncoupling
Where should you park a set of doubles to uncouple the rear trailer?
- AAt an angle so you can see the dolly in your mirror
- BOn a slight downhill grade so the trailer rolls free
- CIn a straight line on firm, level ground
- DOn soft ground so the landing gear sets firmly
Show answerHide answer
Answer C In a straight line on firm, level ground
Line the rig up straight on solid, level ground and set the parking brakes so it cannot move. Chock the second trailer if it has no spring brakes.
Texas CDL Handbook §7.2.2
Q12Uncoupling
Why should you never unlock the pintle hook while the dolly is still under the rear trailer?
- AThe dolly's brakes would lock up
- BThe rear trailer's landing gear would collapse
- CThe air lines would pull out of the glad hands
- DThe tow bar can snap upward, possibly hurting someone and making it hard to hook up again
Show answerHide answer
Answer D The tow bar can snap upward, possibly hurting someone and making it hard to hook up again
The tow bar can snap upward, which can hurt someone and make the dolly hard to hook up again. Pull the dolly out from under the trailer first, then release the hook.
Texas CDL Handbook §7.2.2
Q13Uncoupling
In what order do you take apart a triples rig?
- AUncouple the third trailer first, then treat the rest like a double
- BUncouple the first trailer from the tractor, then the other two
- CUncouple the middle trailer first, then the other two
- DUncouple all three at the same time
Show answerHide answer
Answer A Uncouple the third trailer first, then treat the rest like a double
Start at the back: pull the dolly out from under the third trailer and unhitch the dolly as you would for doubles. Then uncouple the rest as you would any double.
Texas CDL Handbook §7.2.3
Q14Inspection & air checks
In a set of triples, how should the air shut-off valves at the rear of the middle trailer be set?
- AClosed
- BClosed for the emergency line, open for the service line
- COpen for the emergency line, closed for the service line
- DOpen
Show answerHide answer
Answer D Open
Shut-off valves at the rear of every trailer except the last must be open so air reaches the trailers behind. Only the valves at the rear of the last trailer are closed.
Texas CDL Handbook §7.3.1
Q15Inspection & air checks
When inspecting the pintle hook on doubles or triples, what should you confirm?
- AThat the hook is greased and left unlatched
- BThat the hook is open so the dolly can turn freely
- CThat the safety chains are hooked to the pintle hook
- DThat the dolly's pintle eye is in the hook and the hook is latched
Show answerHide answer
Answer D That the dolly's pintle eye is in the hook and the hook is latched
The pintle eye of the dolly must be seated in the trailer's pintle hook, and the hook must be latched.
Texas CDL Handbook §7.3.1
Q16Inspection & air checks
A spare tire is carried on the converter dolly. What should you check?
- AThat it is moved to the tractor before the trip
- BThat it is removed before every trip
- CThat it is held securely
- DThat it rests loosely so it can be reached quickly
Show answerHide answer
Answer C That it is held securely
If the dolly carries a spare tire, make sure it is secured so it cannot come loose.
Texas CDL Handbook §7.3.1
Q17Inspection & air checks
During the air-flow check on doubles, how do you send air into the service line?
- APush in the red trailer air supply knob
- BOpen the dolly air tank petcock
- CApply the trailer handbrake
- DPull out the parking brake knob
Show answerHide answer
Answer C Apply the trailer handbrake
Pushing in the red trailer air supply knob fills the emergency (supply) lines. The trailer handbrake puts air into the service line, so service pressure can be checked at the rear.
Texas CDL Handbook §7.4.1
Q18Federal rules
Under federal definitions, what is a semitrailer that rides on a converter dolly considered to be?
- AA pole trailer
- BPart of the truck tractor
- CStill a semitrailer
- DA full trailer
Show answerHide answer
Answer D A full trailer
Under the 390.5 definitions, once a semitrailer is fitted with a converter dolly (an extra front axle), it counts as a full trailer.
49 CFR 390.5
Q19Federal rules
If a converter dolly's tow-bar fails or comes loose, what must the safety device (such as safety chains) prevent?
- AThe air lines from separating
- BThe dolly's ABS lamp from turning on
- CThe tow-bar dropping to the ground
- DThe dolly brakes from applying
Show answerHide answer
Answer C The tow-bar dropping to the ground
393.70(d) requires the safety device to keep the towed vehicle from breaking loose and to be connected so the tow-bar cannot drop to the ground if it fails or disconnects.
49 CFR 393.70
Q20Federal rules
Under federal rules, can a double/triple trailers endorsement be placed on a commercial learner's permit (CLP)?
- AYes, it is allowed on any CLP
- BNo; the only CLP endorsements allowed are passenger, school bus and tank vehicle
- CYes, but only on a Class A CLP
- DNo; a CLP can never carry any endorsement
Show answerHide answer
Answer B No; the only CLP endorsements allowed are passenger, school bus and tank vehicle
383.93(a)(2) limits CLP endorsements to passenger (P), school bus (S) and tank vehicle (N). The double/triple endorsement can only go on a CDL.
49 CFR 383.93